Anyone have a schematic for wiring a 4 way switch? I'm trying to wire a Duncan Fat Cat and Quarter Pound as follows:
1. Bridge
2. Neck
3. Series
4. Parallel
Anyone have a schematic for wiring a 4 way switch? I'm trying to wire a Duncan Fat Cat and Quarter Pound as follows:
1. Bridge
2. Neck
3. Series
4. Parallel
"I don't play no cords."
-B.B. King
I thought Duncan's site had a ton of wiring diagrams...I just looked and there isn't any one that specifically meets your needs. Sounds like you're going to need some kind of DPST phase switching in there, too.
Regardless, I have the Phat Cat in a new Tele I pieced together, and it's an AMAZING pickup.
"...pray do not imagine that those who make the noise are the only inhabitants of the field;
that, of course, they are many in number; or that, after all, they are other than the little,
shriveled, meagre, hopping, though loud and troublesome, insects of the hour."
-Edmund Burke
I've done exactly that configuration with a 4-way switch, and somewhere around here I have a diagram for how to wire it. I'll take a look and see if I can find it.
Edit: I couldn't find the diagram I used (it might be on my old hard disk...), but I found this one out on the webz:
http://www.acmeguitarworks.com/pdf/t...ay_diagram.pdf
I hope that's helpful.
Last edited by pseudocat; 02-15-2009 at 12:21 AM.
There is a very fine line between "hobby" and "mental illness".
-Dave Barry
"I don't play no cords."
-B.B. King