Please Help ID This Little Cap

[5er Driver]

Can you tell the rating specs for this cap in the pic? Its in a '79 Fender Twin 135w UL. I can't tell anything from the print on it - 7843A 235. There are 5 others in it that are clearly marked 25UF-25VDC-85°C that are the same size as this one, 18mm long and 9mm diameter. I need to replace all 6 but can't ID this one.....




Thanks

[Kap'n]

If that runs to pin 8 of the tremolo tube (and it should), it's a 5uF, 50V capacitor.

[5er Driver]

Thanks Kap'n,

It does run to pin 8 of V 5. Its leaking and is probably a contibutor to a faint ticking noise I hear when the Trem is on. I was able to locate it on a Fender/Rogers/Rhodes schematic that I just downloaded, I'm a noobie in electronics.........The schem isn't dated but is part number 013694 - 135 Watts RMS AMP W/REVERB and VIBRATO. It has a box that says: Used On
Vibros.Rev.
Sup.Six Rev.
Quad Rev.
D.S. Reverb
Twin Rev.

Let me know if you want it.


Edit: I've surfed and surfed but can't find a cap rated at 5uF 50V. The closest I've found is 4.7uF 63V. Will this work?

Thanks Again.

[Keystring]

Close enough.

[Plugger]

Close enough.

Yep. Electrolytic cap values are normally rated with a 20% tolerance anyway. So a 4.7uF could be as high as 5.64uF or low as 3.76uF and still be within manufacturing limits.

-Mark