-
replacing a fuse holder in an old Champ...help!
I've got about a "72 Silverface...the fuse holder is kaput. I've got the chassis out, and I've got the nut loose. I can't quite figure out how the fuse holder comes out. Do I need to disconnect the wires and slide the holder through the front? I'm bumfuzzled! And, it doesn't help that it's cloudy outside and I have every light on I can. I'd appreciate ANY suggestions
-
Forum Member
Re: replacing a fuse holder in an old Champ...help!
I guess the nut is on the outside of the chassis, and then it is logical that the holder should be removed through the inside of the chassis. To completely remove the holder, you ned to desolder the wires of course.
-
Forum Member
Re: replacing a fuse holder in an old Champ...help!
If it's original, the nut is on the inside. The nut needs to be removed and the wires disconnected so the fuse holder can be pulled out from the outside.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules