I Finally Got My Pedal Mess in Order

[5er Driver]

It was this:




Organization is everything. Now it's this:




Everything to the right of the Lehle goes to the SL-X, everything to the left of it goes to the Twin Reverb.




The under side is not finished yet so it doesn't look pretty. After I soldered the last connection I taped everything in place so I could test it. I tested it 4 hours........:



And I still have space for 2 more pedals..............

[Cygnus X1]

Very nice!
So the 9VDC is running into the battery slots on the boxes?

[Offshore Angler]

Apparently, stages are bigger in Stuttgart than they are here!

[Rickenjangle]

Looks like you're using a lot of digital f/x and octaves/pitch shift stuff.

You've got room for 2 more pedals? I'd say you should get a custom-built 4 or 5-looper and take some of that stuff out of the chain if possible...

[5er Driver]

Cygnus - I snapped 9V battery connectors into the existing battery connectors in the pedals and ran the leads through the back of the board. The 9 VDC power supply is connected to these secondary battery connector leads. If you do this, remember the polarity on the secondary battery connector leads is reversed, red is (-), black is (+). It's a lot of work to do this but it keeps the power lines and connections off the top of the board. Only the Lehle has a power connection through the top, there's no provision for battery power on that unit.

Offshore - Nah, the stages aren't bigger over here, I had just accumulated a lot of pedals over the years and needed to tidy up a bit.

Rickenjangle - I was thinking about loopers.......

[bonefish]

had 2 do that recently too...still in the process actually. ordered a pedal pad mps board, unfortunately the power supply is not available yet. was definately needed, as my skb board has been falling apart for a year or so, and i ran out of power two pedals ago.

[chuckocaster]

that looks real clean. good job.