I recently (today) acquired a Strat that has a 4 position rotary (with detents) pot in tone 1. It only impacts the bridge pup. There are slight differences in tone. All sound strat like, but position 2 on it is like pure strat with no hum. Research has not pulled up anything. Before I pull off the guard to see what's going on, anyone have any thoughts? The papers with it offered no insight.
Mark
I would just play it and enjoy it. I got to a point where I'm officially too old to go messing with a perfectly good guitar, LOL. Yup, I have ruined a few!
Last edited by Tele-Bob; 05-15-2024 at 12:32 PM.
If you're bored, you're not groovin'.
Got curious, and looked for a diagram, but no luck, found this article.
https://www.stratcollector.com/news/...-fender-strat/
Not perchance a Fender Japan guitar is it?
"No harmonic knowledge, no sense of time, a ghastly tone, unskilled vibrato, and so on. Chuck is one of the worst guitar players I know" -Gravity Jim
Nope. USA Custom Shop
been too busy to lift the guard and investigate.
Mark
Usually on a Stratocaster it's either a stacked rotary switch that allows for umpteen pickup configs or a Fender Varitone clone. It might be that it is only in the circuit when the 5-way is in the first position.
"No harmonic knowledge, no sense of time, a ghastly tone, unskilled vibrato, and so on. Chuck is one of the worst guitar players I know" -Gravity Jim
That is exactly it; it only impacts pos 1.Originally Posted by Offshore Angler
Mark
A fellow on Strat Talk posted a diagram.
https://www.strat-talk.com/threads/t...-wiring.28669/
Posting Permissions
Reply With Quote