Today I started on my cabs I'm building for the Twin. I mentioned this project in another thread a couple of days ago, and I surprised myself by getting off my lazy ass this morning and getting most of the stuff together to do it.
Again this is the goal, or something like it:
I'm using 3/4" pine for the sides, and I think birch ply for the front and back (3/4" for the front, 1/2" for the back. Here's how far I got today, sorry first one's a little blurry:
Here's a close up of one of the joints, I wish they all looked like this. I just went with a rabbet, because I can't remember how to do a finger joint. Been 10 years since woodshop in high school!
Not my best work, I'm kind of slamming them together. Better than what Fender was slopping together in the 70's though!