-
Forum Member
HSH wiring diagram?
I wanted to know if anyone has a wiring diagram for an HSH strat; I am going to put a '59 model in the neck, a duckbucker in the middle, and a custom/ custom in the bridge position. The more complicated the better, you know with the coil splitting and push/pull pots.
-
Forum Member
There are some in the Strat section on the Duncan site:
http://www.seymourduncan.com/website...hematics.shtml
Check out some of the Humbucker schematics too.
-
Forum Member
Teleologist, thank you, I went to the seymour duncan link and picked out "3 Lil Hums, 1 vol, 2 tones, and 5 way". I figure the full size hums won't make a difference in the wiring, but what about the correct ohms value on the pots? Should I use 500 ohm audio taper pots instead of the 250's?
-
Forum Member
That's a tough call. If you were just using normal series-connected buckers the 500s would probably be better, but when you start splitting buckers a 500 can get too shrill. It may depend on what positions you use the most.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules