biasing Hot Rod Deluxe

[waylon]

I have been posting recently about the upgrades I am doing to my HRD. I am very pleased with the sounds coming from it now. I still need to bias the new Svetlana 6L6GC tubes I have put in there. It says to remove the back cover of the amp and on the pc board there is BIAS TEST POINT with an area to a solder point. Then put your other lead on the ground. Am I correct in using the ground for the power cord (it is a green wire with a phillips screw grounding it). I can not get any type of reading at all. I have my multimeter set for DC volts. Please help what am I doing wrong?

[KCA NOS Tubes]

Hi Wayon:
Grounding to the green wire's lug should be fine.

Are you setting your meter scale to 2 volts? You'll be reading milli volts.
<SPAM REMOVED>

[Preztone]

Originally posted by KCA NOS Tubes
Hi Wayon:
Grounding to the green wire's lug should be fine.

Are you setting your meter scale to 2 volts? You'll be reading milli volts.
<SPAM REMOVED>

Mike,
Is that you? Long time, bud...lonnnggg time! :) - Prez

[waylon]

thank you for your replies. I took my amp to a tech and he set it up for me. Turns out I was doing everything correctly it was just the multimeter is bad. Now this amp sounds really good.
New Reverend Alltone 12" speaker
Svetlana 6L6GC tubes biased at 68mv.
The amp has a lot more creamy sound.