hey dudes,
switched the pre-amp tube...rvrb. still not functioning.
i unplugged both tank wire from amp and checked for an open.
i think i did it correctly.....one lead on the inside "pin" and one on the
outside "ring"--?? my leads are polarized...does one need to go to
a certain part, etc.??
my readings for one cable was around 1 ohm. the other was
around 200 ohms. from what i could find on the net....the 200
ohm reading is probably cool. 1 ohm is a bit low? should be around
8 ohms or so??
any comments, thoughts or goofs are welcome!!